Full Cycle Simulation

During process engineering, in order to gain greater insight into the stamping process, engineers must carry out the simulation of drawing and secondary operations, such as restriking, trimming and flanging as well as springback.

Our state-of-the-art software enables the rapid and accurate simulation of all operations of the stamping process. The simulation of stamping processes with AutoForm software combined with the results evaluation provides you with the necessary information to design the process.

Related Products for New Users

AutoForm-Explorer

Set Up Simulations and Evaluate Results

AutoForm-FormingSolver

Simulate Sheet Metal Forming Processes

Additional Products for Experienced Users

AutoForm-Compensator

Compensate Tool Geometry Based on Springback Results

AutoForm-ToolDeflect

Analyze and Compensate Elastic Tool Deflection

AutoForm-Trim

Optimize the Trim Line and Blank Outline

Training

Customer Use Case

The Partnership Principle
[PDF – 1.32 MB]