AutoForm offers a special base training seminar for new users of the AutoForm software including rapid parametrical tool development using AutoForm-DieDesigner, the cost optimized blank definition, the simulation and evaluation of the entire forming process using AutoForm-FormingSolver and the automatic determination of the optimal trim line using AutoForm-Trim.
The training is subdivided into two sessions. After an initial three-day training session Process Engineering I, the user is already able to productively use the essential basic functions. As soon as the user has gained his first experiences in the productive application of AutoForm, another two-day training session Process Engineering II follows with the main focus on D-Process-Layout and the consolidation of the basic functions.
During this two session training seminar, the new AutoForm users receive a comprehensive base training to use the AutoForm software in each phase of the product development process: product design – feasibility/method planning – prototype tool design – production tool design – process engineering.
This five-day course provides an introduction to the basic AutoForm software modules and is intended for die designers, tooling engineers and method planners.
Troy
Grand Rapids
Online
E-Learning
755 W. Big Beaver Road Suite 300 Troy, MI 48084 USA
Training courses are held at AutoForm’s offices in the USA, Germany, Spain, Italy, France, Japan, Korea as well as in other countries. Please contact your local AutoForm office for further information. Upon request, courses can also be held at customer sites.
Customer Service+41 43 444 6161