Progressive Dies

This course provides participants with in-depth training in applying AutoForm software to validate progressive die processes. The following application streams are covered and streamlined into best practices for engineering and validating progressive die stamping: quick feasibility check on part geometry and initial blank development using AutoForm-StampingAdviser; design, improvement and validation of full, multi-station progressive die operation using AutoForm-Explorer, automatic trim/blank development and optimization using AutoForm-Trim. Special attention will be applied to unique progressive die challenges and concerns: coil carrier behavior, stretch web deformation, and material behavior and failures in multi-stage forming operations.

Audience

This two-day course provides an introduction to the basic AutoForm software modules and is intended for die designers, tooling engineers and method planners with focus on progressive dies.

USA: Training Courses

Trainings to be scheduled upon request. Please send us your filled in request for quotation and we will contact you.

Contact

755 W. Big Beaver Road Suite 300
Troy, MI 48084
USA

Worldwide: Training Courses

Training courses are held at AutoForm’s offices in the USA, Germany, Spain, Italy, France, Japan, Korea as well as in other countries. Please contact your local AutoForm office for further information. Upon request, courses can also be held at customer sites.