AutoForm Training Seminars

Robust Process Improvement

Worldwide: Training Seminars

Worldwide: Training Seminars

Training seminars are held at AutoForm’s offices in the USA, Germany, Spain, Italy, France, Japan, Korea as well as in other countries. Please contact your local AutoForm office for further information. Upon request, the seminars can also be held at customer sites.

USA: Training Seminars

Location: Troy, MI
Grand Rapids, MI
Duration: 3 days
Price: $ 1500 US / Participant
Dates Troy
  • June 26 - 28, 2017
  • August 7 - 9, 2017
  • October 11 - 13, 2017
  • December 18 - 20, 2017
Dates Grand Rapids
  • October 30 - November 1, 2017
Documents Grand Rapids
Contact
AutoForm Engineering USA, Inc.
Attn: Kidambi Kannan
755 W. Big Beaver Road
Suite 300
Troy, MI 48084

+1 888 428 8636 x 104
+1 888 528 8636
E-mail

The training introduces a systematic procedure, using AutoForm-Sigmaplus, for part and tool development, as well as the process design, through the analysis of the influence and sensitivity of design parameters on the forming results.

  • Definition of design parameters such as part radius, addendum, drawbeads, blank shape, binder force, etc.
  • Issue-based evaluation and analysis of the results for the improvement of the forming process

The second part of the training will focus on robustness. The analysis of uncontrollable process parameters provides information on the robustness of the process.

  • Definition of scattering parameters such as material properties, friction, binder force and blank insertion position
  • Analysis and evaluation of the process robustness with respect to the compliance with required quality targets, such as robust springback, the absence of cracks, wrinkles, skid lines etc.

In the third part of the training, the combination, in an AutoForm-Sigmaplus analysis, of these two approaches will be introduced to you, providing an analysis of the influence of the modification of design parameters on the process robustness.

Products

  • AutoForm-Sigmaplus
  • AutoForm-DieDesignerplus

Audience

This three-day course is recommended for part designers, feasibility engineers, die designers and tool makers. Experience with AutoForm-ProcessExplorerplus and AutoForm-DieDesignerplus is required.

Training seminars are held at AutoForm’s offices in the USA, Germany, Spain, Italy, France, Japan, Korea as well as in other countries. Please contact your local AutoForm office for further information. Upon request, the seminars can also be held at customer sites.

Contact AutoForm Engineering

Do you have any question? Would you like to contact us? Please fill in the form below (fields marked by * must be completed in order to send this form).

Contact AutoForm Engineering

Thank you very much. Your request has been successfully sent.