AutoForm Training Seminars:
Training Registration Japan

The training seminars in Tokyo are normally conducted in Japanese. Upon request, the seminars can also be given in English, and additional training seminars are also available.

The training seminars typically start at 9:00 AM and end at 5:00 PM.

To ensure the efficiency of the training seminars, the number of participants per course is limited. Therefore we recommend registering as soon as possible. If a training seminar is full, we will suggest alternative dates for a future seminar.
 

General Documents
	Calendar 2010	[pdf - 290 KB]
	General Request Form	[pdf - 52 KB]
	Location / Map AutoForm Japan K.K.	[pdf - 68 KB]
	Location / Map Sumisho Computer Systems Corporation	[pdf - 56 KB]

Register for Training
	Part Design	[pdf - 56 KB]
	Feasibility Assessment	[pdf - 56 KB]
	Bidding & Planning I	[pdf - 56 KB]
	Bidding & Planning II	[pdf - 56 KB]
	Process Design I and II	[pdf - 76 KB]
	Hydroforming	[pdf - 54 KB]
	Practical Process Planning	[pdf - 56 KB]
	Simulation of Forming Operations	[pdf - 56 KB]
	Simulation of Progressive Dies	[pdf - 56 KB]
	Springback I	[pdf - 56 KB]
	Springback II	[pdf - 56 KB]
	Process Improvement	[pdf - 56 KB]
	Robustness	[pdf - 56 KB]
	Hot Forming	[pdf - 56 KB]
	Wear Analysis	[pdf - 54 KB]
	Deep Drawing	[pdf - 54 KB]
	Draw Die Development	[pdf - 54 KB]
	Material Behavior	[pdf - 54 KB]
	Applied Simulation Fundamentals I	[pdf - 58 KB]
	Applied Simulation Fundamentals II	[pdf - 58 KB]

For further information, please contact:
AutoForm Japan K.K.
Attn: Hisashi Takizawa
Level 9, Orix Shinbashi Building
5-8-11 Shinbashi, Minato-ku
Tokyo 105-0004