AutoForm Training Seminars

Simulation of Progressive Dies

This course provides participants with in-depth training in applying AutoForm software to validate progressive die processes. The following application streams are covered and streamlined into advanced techniques / best practices for engineering and validating progressive die stamping: quick feasibility check on part geometry and initial blank development using AutoForm-StampingAdviser^plus; design, improvement and validation of full, multi-station progressive die operation using AutoForm-ProcessExplorer^plus; automatic trim/blank development and optimization using AutoForm-Trim^plus. Special attention will be applied to unique progressive die challenges and concerns: coil carrier behavior, stretch web deformation, and material behavior and failures in multi-stage forming operations.

Products

• AutoForm-StampingAdviser^plus
• AutoForm-ProcessExplorer^plus
• AutoForm-DieDesigner^plus
• AutoForm-Trim^plus

Audience

This one-day course is intended for AutoForm users, tool designers, formability engineers, and analysts who need to apply AutoForm-ProcessExplorer^plus to progressive dies. This is an advanced training course; participants need to be proficient in the use of AutoForm-ProcessExplorer^plus for stamping process set up, simulation and post-processing. Experience with AutoForm-Trim^plus is useful.

Training seminars are held at AutoForm’s offices in the USA, Germany, Spain, Italy, France, Japan and Korea. Upon request, the seminars can also be held at customer sites. Please contact your AutoForm team to schedule a session.